Dustfree Blasting Wet Abrasive Blast Cabinet with Cart and
Turntable
Wet Blast Cabinet (Power 380V±10%/50Hz/3Phase; 220V±10%/50Hz/Single Phase)
| Model | Working cabinet size(mm) | Total size(mm) | Compressed Air Supply | Power |
| TS9065W | 900x650x600 | 1000x1000x1700 | 3-7bar(kg/cm2) | 220V 50HZ |
| TS1010W | 1000x1000x1000 | 1100x1400x2090 | 5-8bar(kg/cm2) | 380V 50HZ |
If you can't find suitable model, contact with us, we can design it
for you.
Wet blast cabinet
Wet blast cabinets are designed for wet blasting cleaning. There is
a wide range from small manual cabinets suitable for automotive
workshops to large automatic machines used for special
applications, such as the surface preparation of wire and extruded
products and also automatic cleaning of complex components and
dies.
Wet blasting provides extremely consistent and reproducible surface
treatment to clean, degrease, descale etc. or polish various
products of various geometry and material (from plastic and soft
metals to steel or exotic materials) without the use of harsh
chemicals or dusty mechanical action.
Our wet blasting process is a solvent and dust-free blasting
process and is safe also for the operator. Abrasive solution is a
special mix of water and media, sometimes also a special detergent.
This mix is projected at the work piece through an advanced blast
nozzle.
Because no solvents or other potentially hazardous chemicals are
used by the wet blast process, it is not subject to any solvent or
dust emission legislation.
Wet blast cabinet can be used for:
1. Clean up mold, heat treatment, welding parts, castings,
forgings, oxide scale, residual salt and slag, cleanup quality can
be achieved Sa3 level.
2. Clean up small burr, surface remain of machining parts.
3. Change the roughness of surface Ra valve.
4. Can be used as pretreatment processing a surface prior coating,
plating. To get active surface, to improve the adhesive force of
coating, plating layer.
5. It can be used for finishing processing of high precision and
complex shape parts, which other processing methods difficult to
complete.
6. Used to improve the physical and mechanical performance of the
workpiece, Such as changing the surface stress state, improve
lubrication conditions of complexes coupled parts, to reduce the
noise in the moving of complexes coupled parts.
7. Suitable for full renovation of the old parts.
Back side picture of machine
