Q326 Rubber Belt Tumble Shot Blast Machine With 150L Volume With
PLC Control
Description
Tumble blasting machine with rubber belt is ideal for processing
mass-produced parts, which can be tumbled and exposure of all
surfaces to the blasting stream, with high cleaning efficiency.
Using high speed shots accelerated by rotation impeller hit on
surface of work pieces, to get the good cleaning result.
Suitable for treating castings, forgings and heat-treated
workpieces of various size, this system can be extended to a fully
automatic system with the additional peripheral loading and
unloading equipment.
Characters
1.Adopts large volume of centrifugal blast wheel, with high
blasting speed, can significantly improve the cleaning efficiency,
obtain the good cleaning quality.
2.It adopts wear-resistant rubber to reduce the damage of workpiece
and noise of equipment.
3.The blasting area is protected by high chromium wear-resistant
plate, compare to rubber plate used before, the service life is
greatly improved, and the appearance is nice, easy to replace, it
is the most popular way to protect the blasting cabinet.
4.The utility model has the advantages of compact structure, high
production efficiency, good cleaning result, safe and reliable
operation and stable performance, easy to operate.
Specification
Model Spec. | Q326 |
| Productivity(T/h) | 0.6-1.2 |
| Maximum Load (kg) | 200 |
| Maximum Product (kg) | 10 |
| Disc Dia.(mm) | 600 |
| Capacity(m³) | 0.15 |
| Shot Flow(kg/min) | 100 |
| Separate Type | Sieve + Air Wash |
| Air Volume(m³/h) | 2200 |
| Power(kw) | 10.85 |
Parts Introduction
This is a small cleaning equipment, mainly composed by the cabinet,
blasting system, abrasive recycle system, dust collector,
electrical system and etc.
a. Blasting Cabinet(Longer Serive Time)
Inside the cabinet, there equips with wearing-resistant rubber to
carry the products rotate. The shell is protected by special
wear-resistant alloy shield mounted on end sides of belt, which is
made by high chromium iron casting.
b. TS Blast Wheel (High Efficiency + Longer Service time)
It is key part of shot blasting machine, consists of blades,
control cage, wheel disc, impeller, protective linings, wheel
house, feeding pipe, special motor and etc.
c. Door (Good Sealing)
It is single swing door hanging with wear-resistant rubber to
protect the door and sealing.
d. Elevator + Air Wash Separator
(with advanced design, dust and abrasive can be separated up to
99.5%)
To ensure conveyor belt not slip when machine is working, the
pulley was made into a squirrel cage, that increase friction
between belt and pulley, reduce the press-tightening force, extend
belt service life. While elevator is equipped with a tension
device, belt can be tensed by adjusting the upper bolt when it
loose.
e. Cartridge Dust Collector(More Easier to Clean)
Pulse-jet Air Clean System
The dust collector has a push button to “pulse” the cartridges with
a jet of compressed air between blast cycle to purge the filter.
Upgrade option, the part can be programmed in PLC.
f. Electrical Control Panel (More Safty)
Qualified electronic components from famous company, such as
Schneider, Chint or other Equivalent brand;
With Emergency Button; Control Voltage 24V;
Interlock System: there is a limit switch above the door, only
after the door closed, can the blasting wheel be started.
Before and After
Package
